Swimming pool pumps are circulating water equipment, also known as swimming pool circulating pumps. It is one of the most important equipment in the swimming pool project, and it is an important guarantee for the circulating water supply of the swimming pool. Therefore, the correct use and maintenance of swimming pool pumps in daily work is very necessary.
The swimming pool water pumps are equipped with filter sand tanks, so that the swimming pool can be cleaned daily while the water is circulating. So, what is its use like?
First of all, before starting the water pump, you need to check: adjust the filter sand tank to filter state; check the valve; check whether the hair collector is blocked and whether there is air, if so, clean it in time; check whether the tank cover is leaking (the tank cover must not leak gas, to be tightened); the inspection of the dosing tank. Check whether there is air accumulated in the main return pipe, and if so, it must be removed through the drain valve.
Secondly, start-up operation: first turn on a water pump motor, and then turn on the water pump that needs to be used after the water pump motor is running normally.
Finally: it is not completed after starting up, we still need to observe whether the swimming pool pump is operating normally, such as recording the index of the pressure gauge on the filter to check whether backwashing is necessary; check the operation of the pump, whether it is running smoothly and without noise; check each dosing system Whether it is operating normally; go to the pool to visually check whether the water is normal from each water injection port. In short, it is to check whether all its parts are normal. If there is a problem, you need to find the cause of the problem and solve it.
Note: The swimming pool water pump has many functions, different functions, we need to pay attention to different aspects: for example, the filter function we need to pay attention to whether there is blockage, whether there is inflation, etc.; filter backwash function: first we need to look at the sand filter tank If the reading of the pressure gauge is higher than 2.5kg/cm2 or above, it is necessary to backwash the filter sand tank immediately, and then start using it according to the instruction manual. Observe the clear water mirror during use, and turn off the backwashing water pump after cleaning; the drainage process In this process, we must try to prevent the interruption of the pump work.
In fact, as long as we are very familiar with the instruction manual of the swimming pool water pump and strictly follow the instructions on the operation, it will be fine.
Finally, swimming pool pump maintenance should do the following:
1. Check and clean the sand tank regularly.
2. Regularly check the sealing ring of the pump head cover. If it is damaged, please replace it in time.
3. Keep the motor clean and keep the air outlet of the motor unobstructed.
4. Occasionally, the shaft sealing ring of the motor will be worn and should be replaced in time.
5. In winter, the accumulated water in the pump head should be removed, the inside and outside of the pump should be cleaned, and the pump should be stored in a dry and well-ventilated room.